2795-3 Triple Strobeswitch™ Assembly

  • SKU: 2795-3
  • Regular price
  • YOUR PRICE: $912.80

PRODUCT OVERVIEW

The Model 2795-3 Triple STROBESWITCH™ is a compact low cost three-detector system which detects a special strobe light signal and opens access gates to allow quick entrance.

The detector is activated by the strobe emitters used by most fire and police department emergency vehicles used to control traffic signals en route to an emergency. The three 1790–1014 STROBESWITCH™ detectors interface with the TOMAR or GTT OPTICOM® optical signal emitters. Each detector features a 1/2” female pipe hub mounting base.

Key Features

  • Perfect for gate access properties that need to give access to first responders quickly and effectively.
  • Designed to operate indoors or outdoors (is designed to withstand outdoor elements and severe weather situations).
  • Can be interacted with TOMAR or GTT OPTICOM® optical signal emitters.
  • Each detector features a 1/2” female pipe hub mounting base.

How TOMAR'S Triple Strobeswitch™ Assembly Works

  • The emergency vehicle uses a special strobe light to transmit a continuously flashing optical signal.
  • The TOMAR 2795-3 STROBESWITCH™ receives this signal, and if the signal format is correct, activates a relay. The relay contacts may be used to control security gates, fire department garage doors, and other devices.
  • Signaling is optical by line of sight, and the 2795-3 can operate indoors or outdoors, in bright sunlight, or in any weather.
  • The unit is not susceptible to radio frequency interference, and uses digital frequency discrimination to reject unwanted signals, such as flashlights, emergency vehicle lighting systems, flashing signs, etc.

* Registered trademark of the GTT Corporation.


1790M-3 Strobeswitch Product Specs

  • Range: 200 feet typical, but depends on the intensity of strobe emitter
  • Field of View: 10º vertical, 90º horizontal
  • Signal Acquisition Time: 0.64 seconds
  • Function Indicator: The unit has a red LED that illuminates whenever a proper optical signal is received. The LED is visible through the viewport and can be seen for 25 feet or more. This feature can be used with the optional Hand Held Tester to verify the unit’s operation.
  • Frequency:
    • F14 = 14.035 Hz ± .25 Hz ( high priority )
    • F10 = 10.000 Hz ± .25 Hz ( low priority )
  • 1790M–2 Power Module:
    • Voltage: 12–24VDC AC/DC
    • DPDT relay output: 2A @ 30VDC, 0.6A @ 120VAC
    • Time Delay: 0–30 minutes plus continuous latch mode
  • Remote reset

Product Cut Sheets and Install Sheets

About Strobeswitch™